Aquí dejo una foto y las instrucciones
HONDA PROGRAMMING INSTRUCTIONS
PROGRAMMING A (All years unless otherwise listed)
Accord 97-06 Element Pilot
Civic 99-06 Insight Prelude
CRV Odyssey 99-06 S2000
PROGRAMMING B
Accord 94-97 Odyssey 95-98
PROGRAMMING C
Civic 96-98
PROGRAMMING D
Passport 94-2002
PROGRAMMING A
1)Switch ignition on.
2)Within 4 seconds, press lock button on the first remote transmitter for 1 second.
3)Within 4 seconds, you must switch ignition off.
4)Within 4 seconds, you must switch ignition on.
5)Repeat steps 2, 3, & 4, twice.
6)Within 4 seconds, press lock button of first remote transmitter for 1 second.
7)System should now lock and unlock vehicle indicating programming mode is activated.
8)Within 10 seconds, press lock button of first remote and unlock once.
9)Press lock button if ech remaining remote to be programmed, allowing doors to lock and unlock once as each remote is programmed.
10)Switch ignition off and remove key.
11)Check operation of all programmed remote transmitters.
1) Encienda la ignición.
2) Dentro de 4 segundos, presione el botón de cerradura(esclusa) sobre el primer transmisor remoto durante 1 segundo.
3) Dentro de 4 segundos, usted debe apagar la ignición.
4) Dentro de 4 segundos, usted debe encender la ignición.
5) Repetir pasos 2, 3, y 4, dos veces
6) Dentro de 4 segundos, presione el botón de cerradura(esclusa) de primer transmisor remoto durante 1 segundo.
7) El sistema ahora debería cerrar y abrir el vehículo que indica el programa del modo es activado.
8) Dentro de 10 segundos, presione el botón de cerradura(esclusa) de primero remoto y abra una vez.
9) la Prensa cierra el botón si ech dejando remoto ser programado, permitiendo a puertas para cerrarse y abrir una vez como cada remoto es programado.
10) Apagar la ignición y quitar la llave.
11) Comprobar la operación de todos los transmisores programados remotos.
PROGRAMMING B
Programming required if remote transmitter added, replaced, or system malfunction.
1)Open driver side door.
2)Press and hold driver's door lock button in unlock position.
3)Within 10 seconds, you must insert and remove ignition key from ignition switch 5 times. Reinsert
key into ignition switch.
4) System should now lock and unlock vehicle to indicate programming mode is activated.
5)Press remote transmitter lock button or unlock button.
6)Except driver's door system should lock and unlock vehicle to indicate programming has been
7) Press remote transmitter lock or unlock button again. System should lock and unlock vehicle.
8)Press lock button or unlock button on remaining remote transmitter to program. _
9)Except driver's door, system should lock and unlock vehicle to indicate programming has been
10)Press lock or unlock button again. System should lock and unlock vehicle.
11)Release driver's door lock button.
PROGRAMMING C
1)Within 5 seconds, press and hold valet button. (Valet button located on radio-between AM/FM button and CD/TAPE button.)
2)System hould now lock and unlock vehicle to indicate programming mode activated.
3)Within 5 seconds, press lock or unlock button on first remote transmitter.
-Within 10 seconds of each other, press the lock or unlock once as each remote transmitter is programmed.
4)Programming procedure is completed.
5)Release valet button, switch ignition to off, and remove key.
6)Check operation of all programmed remote transmitters.
PROGRAMMING D
1)Open driver's side door.
2)Insert key into ignition switch.
3)Switch ignition to 'ACC position and back to 'LOCK' position 3 times within 10 seconds.
4)Within 10 seconds, close and open driver's door twice.
5)Within 10 seconds:
Switch ignition to 'ACC position and back to 'LOCK' position
a)5 times (if lost or stolen)
3 times (if adding a replacement)
6)System should now lock and unlock vehicle to indicate programming mode activated.
7)Within 20 seconds, press lock button of remote transmitter.
8)System should now lock and unlock vehicle.
9)Within 20 seconds, press unlock button of remote transmitter.
10)System should now lock and unlock vehicle.
11)Remove key and close driver's door.
Editado por BAZOCA, 10 April 2008 - 20:29:19.
